Knowing what the dimensions should be was a critical first step.
So my starting point was with a laminated bench top I saw at Bunnings for under $100.
The first thing I did was build a frame slightly smaller than the bench top itself which would become the top of the carcass. I made it smaller to allow for a small overhang.
I glued and screwed everything together making sure everything was properly straight and square. Then, using more 4x2 timber lengths I made a few more legs for the frame of the carcass.
I ripped a bit of old decking in half on the table saw, length ways to create a couple of rails which I would use to attach the legs. Also, the plywood base of each cupboard would attach to these rails.
The next thing that was needed were some cupboard doors which I made out of plywood attached to a light timber frame for each door. This was the most challenging part of the job in view of my limited cabinet making skills, but I was very pleased with how it was all coming together at this point. In the mean time I added a couple of shelves and continued to cover the entire cabinet with plywood to finish everything off nicely.
Getting it to this stage I needed a few bits of hardware including hinges and door/draw handles so I decided to replace the existing handles on the drawers to make sure everything matched. In trying to match everything I also had to sand the drawers back to their original lighter colour, although I knew it wouldn't match perfectly, but I told myself: close enough would be good enough.The plywood I used was untreated so I was aware I would need to cover it with a protective layer of stain or varnish. At first I thought of using the same dark stain as I used on that planter box (on the right hand side in the picture above). I thought by doing that, I could hide the fact that there were different coloured timbers showing, but because it's such a light airy space I felt a lighter colour would be better despite the variation in timber colours.
Because I used a stain, that only accentuated the different coloured timbers rather than hid the fact, but I'm not too worried about that. Finally, using the power I'd hooked up for the space, I repurposed a spare fridge, toaster and kettle from the house. I also ran power to a set of down lights which I installed over the bench. Then to finish off I added a splash back on the wall above the bench, which I recycled from the old bathroom.
So now it's a semi-functional al Fresco Kitchen where simple snacks and light meals can be prepared. At this stage there are no proper cooking facilities but I reckon a microwave, electric frying pan and maybe a portable gas cooker might do for basic cooking.







